Enter relevant information on INSTALLATION CHECKLIST. Note the engine RPM at idle prior to installation.

On ALL computer aided vehicles DISCONNECT negative post on the battery.

NOTE: On all ford pick up trucks, disconnect all battery cables for at lease 30 minutes prior to installation of energy cell. (press the brake for 3 to 4 seconds to release built up energy.

1. Locate a NON-MAGNETIC intake fuel line for the location of the EnergyCel™.

2. Avoid installation on areas with a HIGH DEGREE of heat. On or next to the engine block or turbo for example.

3. All 3 magnets should be evenly distributed around fuel line with at least 2 to 3 inches of straight fuel line before any bends to allow the molecules to re-align and spread apart.

4. The highly magnetic EnergyCel™ can not be mounted next to anything that is electronic in nature, i.e. computers, electric solenoids, distributors, etc.

5. Attach EnergyCel™ making sure that it fits securely without over tightening nuts to cause any crimps in the fuel line. On a narrow fuel line you may need to use the supplied narrow adhesive strips.

6. Following correct installation, start vehicle and run for 2 minutes at 2000RPM then enter RPM at idle. There should be a reduction in RPM but any change is an indicator that the unit is working.

7. Emissions could temporarily rise due to release of carbon build-up inside engine, but significant positive results should occur within two tanks of fuel or more.

As the engine becomes cleaner, the fuel mileage should increase.

It is VERY IMPORTANT TO CHANGE THE OIL AND FILTER within 1500 miles of the EnergyCel™ installation date as the oil will become dirty faster than normal because the engine is burning the carbon deposits.

There are no short cuts; all installations should follow these instructions.

The unit works 100% of the time if installed correctly!